Electrical and electronic bench failure analysis
When the cause is not obvious from the work order, the failed hardware still has something to say.
Electrical and electronic bench failure analysis is for the component or assembly that failed, and the work order still does not explain why. The work is hands-on: inspect, measure, document, and write down what the evidence supports — and what it does not.
How the bench is used
Typical work includes power-quality capture, insulation and motor testing, ultrasound and thermal inspection, and component-level electronics troubleshooting. The equipment list lives on the About page so you can see what is actually on the bench. Findings can stand alone or feed a root cause investigation.
What you leave with
- Photographs and measurements that support the findings
- A short written note on the likely failure mechanism and any remaining uncertainties
- Suggestions for corrective action or further tests, when the evidence warrants them
This is not a catch-all lab for every discipline. If the problem is outside the bench, you will hear that promptly.
Scoped per job. No retainers, no mystery.
- A conversation, freeYou describe the asset, the pain, and what “fixed” looks like. You get an honest answer on whether the work is a fit and what it takes.
- A scoped proposalDeliverables, timeline, and price in writing before anything starts. You approve the scope, not a blank check.
- The work, with your teamSessions and analysis done alongside your people, so the method stays in the building when the engagement ends.
- Deliverables you can act onA task list, a business case, or an investigation report — in your format, ready to use.
Work can be purchased by purchase order or invoice. A W-9 is available on request. Use the PO / invoice form, or email inquiry@apexreng.com.
Everything you share stays yours. Plant data, failure history, drawings, and production numbers are never disclosed without your express written permission.
Questions that usually come up
What kinds of failures?
Electrical and electronic components and assemblies: for example power quality events, insulation or winding issues, control-board failures, and similar bench-diagnosable problems. Mechanical metallurgy is not the default scope unless arranged separately.
What equipment is on the bench?
The current list is on the About page and includes power-quality, ultrasound, thermal, motor-testing, and oscilloscope equipment. If a job needs something that is not on the bench, that will be said before work starts.
How is it priced?
Per job, as a fixed scope, often combining bench time with a short written findings note. On-site days, when needed, are $1,200 plus travel.